1965 Buick Electra/Wildcat 425CID Dual Carb Choke Tube 1pc, OE SteelThese preformed engine lines replace the factory choke tubes that run from the intake manifold to the choke following factory routing. Our replacement lines are engineered from factory original tubes, CNC manufactured for precision, and include the correct fittings and flares (where equipped). Please note that these lines are intended to work with factory carburetors and intake manifolds.

1966 Tri Power PCV Crankcase Vent 3/8" Printed Hose Kit

1969-79 GM Standard Fan Spacer 1-1/2" 1pc

4 x 3/8”-24

This kit includes two 15” hoses each with a -3AN female end and a 1/8” pipe thread male end for a 17” overall length

This clip kit includes all clips necessary to secure the brake lines to the chassis of the car: five triple clips

1967-70 Chevrolet GMC K10 K20 Blazer Suburban 4wd Front Drum Stanless Braided Brake Hose Kit 3pc

These preformed brake lines will replace the lines that run from the front caliper or wheel cylinders to the rubber brake hose on your vehicle

1964-77 GM Ball Stud Clutch Z Bar To Engine Block With Seal

·         (2) 21” Power Braid® hoses each w/ a 3/8”-24 female & a 10mm banjo

These preformed transmission lines replace the original transmission modulator lines and run from vacuum to modulator following the factory routing

1964-79 GM Manual Trans High Performance Throw Out Bearing

This pre-fabricated tube is 50” in total length including the 3/8” tubing and 5/8”-18 stainless fittings