Gas cylinders. Refillable welded steel cylinders. Test pressure 60 bar and below1 Scope This International Standard specifies the minimum requirements concerning material selection, design, construction and workmanship, procedure and test at manufacture of refillable welded steel gas cylinders of a test pressure not greater than 60 bar1), and of water capacities from 0,5 l up to and including 500 l exposed to extreme worldwide temperatures (50 C to +65 C) used for compressed, liquefied or dissolved gases. Transportable large

BS EN 16770 also provides you with solutions to minimize the risk of these hazards

BS EN 2240-063 is the 63rd part of a multi-part series that focuses on requirements for incandescent lamps for aerospace applications to ensure the manufacturing of efficient incandescent lamps

gaining the benefits associated with each step

This document specifies two methods for the determination of the thermal stability of products and compounds based on vinyl chloride homopolymers and copolymers (referred to simply as PVC in the following text) by the extent of the discoloration that occurs when they are exposed

BS EN 1817 on homogeneous and heterogeneous smooth rubber floor coverings is useful for:

BS EN 6059-309 covers terms and definitions

600/1 000 V cables

response time

key drivers for life cycle cost reduction pumping cost

The method described in this International Standard is less accurate for lambswool and for wool which is appreciably medullated (see Annex D) and heavily dyed wool

specifically how to schedule actions for execution at some future time and how to cancel them should the need arise

in accordance with the principles set out in BS ISO 55000