Shrink chuck 4,5° SK 40 - 10 - 80Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

For mounting straight-shank tools in collets

E2= 14 pieces

3 / L2=63 HA polished Split Point - Valuetool

Clamping force preadjustable by graduation lines

The clamping screw incorporates a through hole

For the transfer of a defined torque

better chip evacuation

For parts with delicate clamping surfaces

- IP65 degree of protection

Construction:

For face machining

A possible increase of axial force during the tapping process is reduced to a minimum