Hot Racing - 3 Cell Twin 40mm Twister Motor Cooling Fan Kit, for 1/5 ArrmaRequirements: Installation Recommended to loosen fan screws during installation, then tighten again after installation. This will help minimize tweaking and binding the fan. Medium strength thread lock (blue threadlocking compound) on fan mount screws Ensure fan blades are protected This system uses a 7 to 12 v power souse best to run wire it to a separate battery *Best Use A Separate power source (3 cell battery pack) *Replacement Hot Racing

Screws and washers included

This is a 1

Check the wheelbase tech specs of your Axial vehicle to determine compatibility

Maximum Charge Rate: 2C (4

GR01 Aluminum Skid Plate (Titanium Gray): GOM

6 Washer [2

pre-cut vinyl window masks

you are totally free to have an all-new design and colour combination on your Jumpshot

Following the end of the Korean War

A constant voltage for your servos will ensure consistent performance at the start and end of the your race compared to typical NiMH receiver battery packs

effective and highly attractive

The main battle ship unit