Cutting tool data representation and exchange - Creation and exchange of 3D models. Solid end mills1 Scope This part of ISO TS 13399 specifies a concept for the design of tool items, limited to solid (non indexable) end mills, with the usage of the related properties and domains of values. This part of ISO TS 13399 specifies a common way of design simplified models that contain the following: definitions and identifications of the design features of solid (non indexable) end mills, with a link to the properties used; definitions and identifications

9— Water quality

Water-borne type preservative solutions manufacturers

Electrical apparatus for explosive gas atmospheres - Part 10: Classification  of hazardous areas

The test method documented in BS EN 61000-4-5 describes a consistent method to assess the immunity of an equipment or system against a defined phenomenon

Model PKI disclosure statement

the minimum requirements for the performance of the instruments used are also given as a guideline for personnel involved in testing

downhole sensors and selective isolation devices

give guidance on their selection nor describe methods of representing information in coded form

rail traction and marine use

These cables are not primarily intended for direct connection to a low impedance source

What is BS 4524- Residue on evaporation on a water bath about

NOTE 1 The use of gases which are dirty