Duet Expansion BoardIn stock, ready to ship. Special breakout board for the Duet Wifi and Duet Ethernet. The stepper connections have 6 pin headers Step+ Step Dir+ Dir +5v GND. Theres a 74HCT02 to convert the heater 6 and 7 signals to 5V active high (which also helps protect the Duet) and use two 3 pin connectors providing both 5V and servo control on the same connector. As of May 12th, 2021, all Duet3D products purchased from Filastruder will be eligible for a 12 month

5mm and 3mm

such as compatible interchangeable nozzles in a range of sizes

loosen the nozzle 1 turn each minute while the Filastruder cools

Note that you will probably need additional hardware to connect the couple to your controller board

Optional 5V external power input for powering servos

- These heaters are more than capable of reaching temperatures that will soften the aluminum block shipped as standard with our heaters

No matter how much the spool fills up or the speed of extrusion changes

Faster printing: 200+ mm/s

so hazards are reduced in the event of a thermal runaway

we recommend the PanelDue5i or  PanelDue 7i

Power requirement 5V power from host 3D printer Supply current Board only: 35mA

further improving accuracy