Rubber, vulcanized or thermoplastic. Determination of adhesion to metal. Two-plate method1 Scope This document specifies a method for determining the adhesion strength of rubber to metal bonds where the rubber part is assembled between two parallel metal plates, using the adhesive system under investigation. The method is applicable primarily to test pieces, prepared in the laboratory under standard conditions, such as can be used to provide data for the development of rubber compounds and control of methods of manufacture.

pressurized systems — and provides a means of classifying those filters according to filtration method

These isomers can be determined by chromatography on a chiral HPLC column

Who should use this document

planning and report with the intent to ensure reliable and comparable results when using the reference methods that have been developed and/or adopted by CEN/TC 292

and chemical resistance for the overall performance and durability of the metal substrate

semi-goliath and goliath cranes for general use

The magnetic tests on Earth-orbiting or interplanetary spacecraft missions with very stringent requirements on magnetic cleanliness are needed to ensure that the spacecraft’s inherent magnetic properties meet the design goals

This is accomplished by specifying quality levels and the associated risks of acceptance and rejection

It is applicable both for the cases where each modular cell uses only a single turn-off semiconductor device in each switch position

Manufacturer of corrosion-resistant stainless steel flat products

By adopting BS EN 3155-063

BS EN 62381 defines procedures and specifications for the Factory Acceptance Test (FAT)