End mill holder Weldon SK 30 - 14 - 50Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Delivery: With clamping screw All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

Ø 6 – Ø 32 with h6-tolerance

Clamping range h6 (nominal size only)

Collection of collets

For the coolant supply through the centre of  HSK toolholders

USB Data out

- Parallelism to driver grooves < 0

For mounting straight-shank tools in 2 µm-collets

Extremely strong holding force (increases the holding power by at least 60% compared to standard ER chuck)

load capacity 200kg

Betthöhe H: 0

Coolant pressure up to 100 bar

Type with adjustable safety clutch