Shrink chuck 4,5° SK 40 - 06 - 80Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

Further information on the articles included can be found under the respective article number

Slides hardened and grinded

Clamping positions: horizontal

clamping depth = -

Warranty card

The clamping screw incorporates a through hole

3 µm radial run-out with a 2 µm clamping nut

Ø 125 mm with locks

Extremely strong holding force (increases the holding power by at least 60% compared to standard ER chuck)

For horizontal and vertical clamping of round and flat workpieces

Adaptive interface machine direction (ADINTMS): BMT driven turret interface -size BT65A

Zero-setting at any position for incremental measurement