Rolling bearings. Aligning thrust ball bearings and aligning seat washers. Boundary dimensions1 Scope This International Standard specifies dimensions of single direction and double direction aligning thrust ball bearings with and without aligning seat washers.

BS EN 13001-3-2 deals only with the limit state method in accordance with EN 13001-1

in the event of a fire outbreak

weight loss

Collaborative relationships also lead to better cost and risk management

Surfaces fulfilling the test requirements of this standard are considered to comply with the requirements for impact attenuation in BS EN 1176-1

which are referred to

functional parameters and calibration procedures for each type of test equipment

Steel casting researchers

Why should you use BS 7882 - Calibration of torque measuring devices

10 Legal and other requirements

NOTE: For these essential oils the method given in ISO 37941) should be used

The presence of surface contaminants