Wiegand RFID Conversion Cable with RS232 Serial OutputThis accessory converts the output of a Wiegand RFID reader, and sends the ID via RS232 Serial output. In addition, the cable will also provide the following features: Convert input voltage from 10 30VDC down to the proper DC level for the RFID reader Provides a enable line to control power to the reader Floating or Ground = Off 3. 3VDC = On Note: Another variant of the cable is available to remove this functionality HTD 010 B1 Passes through the LED

Cable is used to connect a 9-pin j1939 device to a 6-pin j1708 vehicle

3 meters (or 1 foot)

The required drivers for the PC will install automatically once the USB cable is connected

with all 9 connections populated

26-bit cards only

and sends the ID to a 1-Wire interface utilizing iButton protocol

The 5-pin cable can be directly connected to the AUX port of the device

(works with CalAmp products to display debug from AUX port)

Chain-able Temperature Sensor (DS28EA00) 30 inches in length

The UART Serial to Android Conversion Cable is specifically designed to work with UART/TTL level serial devices and connect directly to an Android tablet

16-pin OBDII passthru length of 0

Cable is 0