GRACO STUD, CLAMP - (SKU: 621201)The GRACO 621201 STUD, CLAMP is a small hardware component designed for use within GRACO equipment, specifically as a clamp stud. Its material is not specified in available sources, but it is intended to secure or fasten components in place within GRACO air spray systems and related equipment. Key Features: Clamp stud Compatible with GRACO air spray systems, such as the President 10: 1 Ratio Air Spray System Applications: Used in GRACO air spray

Refer to the pump manual for detailed step-by-step instructions

Reliable cycle detection up to 200 CPM (depending on series)

Used in industrial fluid handling systems for sealing 55-gallon drums during fluid transfer

designed as a protective and structural component for GRACO SaniForce High Sanitation Diaphragm Pumps

Replace the filter bag as recommended by the equipment manual or when contamination is detected

Ensure the tube is free from kinks or obstructions before installation

Its intended use is to maintain and restore the performance of spray guns by clearing blockages in critical passageways

Genuine GRACO hoses are factory-tested and meet the highest safety standards

It is typically constructed from durable materials suitable for high-pressure fluid handling systems

Tighten the packing nut to the manufacturer's recommended torque to avoid over-tightening or under-tightening

and is intended to restore or maintain the sealing integrity of the pump’s lower section

It is typically made of durable plastic or vinyl and is intended for identification and branding on the front of the equipment