Shell mill holder SK 50 - 40 - 130Application: For mounting milling cutters with transversal groove. Note: d = 40 d = 60: For large diameter face mill cutters with four additional threaded holes according to DIN 2079. SK 30 without coolant exit bores on the end face Delivery: With drivers, cross head retaining screw and cylinder head retaining screw for cutters with central coolant. For d = 60 only with four fi xation screws according to DIN 912. All holders are made of forged steel

With wrench

Slides hardened and grinded

(applicable up to 21 bar)

Measuring contact points are designed to allow measurements near to the bottom of blind holes

Battery :1

Instruction manual

5 with h4-tolerance and Ø 6 – Ø 32 with h6-tolerance3

- Alignment surface ± 0

From d = 25 on two clamping screws

Can be locked with set screw

The chucking diameter is configured for a tool tolerance of h6

thin thread and pitch diameter oversize