Road vehicles. Product data exchange between chassis and body work manufacturers (BEP) - Coding of loader crane bodywork1 Scope The ISO 21308 series describes a generic system for the exchange of data between truck chassis manufacturers and bodywork manufacturers. It applies to commercial vehicles as defined in ISO 3833, having a maximum gross vehicle mass above 3 500 kg. The process of exchanging the above information can involve chassis manufacturers, chassis importers, chassis dealers, one or more bodywork manufacturers, and bodywork component suppliers, e. g.

playshapes

It does not attempt to articulate

BS 1127-1 applies to screw dies intended for the manufacture of the following threads:

This part of BS EN 752 sets out the performance requirements to be taken into account when planning

Manufacturers and suppliers of circuit breakers

Such areas are indicated in BS 5904 by the use of phrases such as “implementation-dependent”

together with the requirements for their safe use and application

PD IEC PAS 60512-27-200 provides signal integrity tests which test the electrical performance of the wires and the packing structure used to move the signals within the electronic products

BS EN 60684-3-145 to 147 provides users with the standardized designation for sleevings which helps in their identification

Where rules already exist

including self-propelled machinery

It is not applicable to extra heavy-duty electrical rigid steel conduits specified in IEC 60981