End mill holder Weldon SK 40 - 10 - 50Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Delivery: With clamping screw All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

- Warranty card

- The main body is made of aerometal

Alignment of component reference surfaces or edges

- Bed height H: 0

20mm for over 500mm/20" range

Tensile strength in the core of min

Dial Graduation: 1°

Spherical end anvil

Shell mill holders DIN 6357

Extremely strong holding force (increases the holding power by at least 60% compared to standard ER chuck)

Angle reading and adjustment using a vernier

- four measuring methode: standard